Scope of application
Suitable for all kinds of trademark paper, adhesive film and paper slitting. (Tape can also be used for slitting)
Features
1. The power part adopts linkage control of three groups of motors, and the winding control system can control the tension and slip axis speed.
2. The unwinding part is of shaft separated type, equipped with full-automatic tension control and EPC automatic deviation correction device.
3. The tension of the winding shaft is controlled by individual sliding, and the slip is automatically adjusted when the material thickness is not good, so that the tension of each roll is controlled evenly.
4. Finished products are taken out, equipped with a one-piece rotary frame to assist unloading, which can be completed quickly with less time and effort.
5. It is equipped with upper and lower round knife transmission device.
Optional equipment
1. Shaftless discharge seat: lift arm type shaftless clamping, which shortens the feeding time and improves the efficiency.
2. Integrated paper receiving table: This device can make the interface more flat and save material loss.
3. The slitting cutter can be an industrial flat cutter.
Technical parameters
1. Mechanical width: 1.3M/1.6M
2. Raw material diameter: Ø 1000mm
3. Minimum finished product width: 30mm
4. Finished product diameter: Ø 500mm
5. Inner diameter of pipe core: 3 "(76.2mm)
6. Mechanical speed: 0-180m/min
7. Power supply: 380V, 50HZ, 3PHASE
-Due to the continuous improvement of product design, the above information is for reference only.
-If you need detailed data, please contact the business personnel or fill in the specification form, and we will handle it for you as soon as possible!
